![]() |
![]() |
SIZE |
![]() |
FINISHED MEASUREMENTS |
![]() |
MATERIALS Notions |
![]() |
GAUGE |
![]() |
PATTERN NOTES |
C4F = Slip 2 sts to cable needle and hold to front of work; k2
then k2 from cable needle. Crosswaves Pattern: Left Leg |
![]() The charts for this pattern are very large and fit on a letter-sized page. Click here and print the resulting page. |
DIRECTIONS ![]() CO 62[70, 78] sts. Distribute across your needles as you prefer, and join for working in the round, being careful not to twist. Note or mark beginning of round. Ribbing Round: [K1, p1] around. Increase Round: ([K2, kfb] ten times, k1[5, 9]); repeat
once more. 82[90, 98] sts. Work in Crosswaves pattern, until work measures 7.5[8, 9.5] inches from cast on edge, or 2.25[2.25, 2.5] inches less than desired length of leg, ending on Round 12 or 24.
![]() ![]() Heel Flap Setup Round Right Sock: P1; slip this st to last needle of round (it will now be the last st of the round), work in patt to center marker; pfb, sl1 st to cable needle and hold to back of work; k2, pfb from cable needle; work in patt across, p1. Heel Flap Setup Round Left Sock: Work in patt to last st before center marker; slip this st onto next needle (this will become the first st of heel); cont in patt to last 4 sts; slip 2 sts to cable needle and hold to front of work; pfb, k2 from cable needle; pfb. Heel flap will now be worked back and forth on 44[48, 52] sts. Important note: Repeat Rows 1-12 until heel flap measures 2.25[2.25, 2.5] inches, ending with a WS row. Heel Turn Women’s Large/Men’s Medium & Men’s
Large Only: Men’s Large Only:
![]() Purl across 24[26, 28] heel stitches. Pick up and knit 13[15, 15] sts along the side of the heel. (This will be the new start of round position. Place a marker if you wish.) Work in pattern across 40[44, 48] instep sts and place a marker. Pick up and knit 13[15, 15] sts along the side of the heel. Purl to end of round (start of instep sts). Start of round is at start of instep sts, and a marker designates the end of the instep. Begin Gusset Shaping Continue working even as established (pattern across instep, reverse stockinette across sole) until piece measures 7[8.5, 9.25] inches from base of heel, or 2 inches short of full foot length from back of heel to toe. Toe Round 1 (Decrease Round): P1, p2tog, p to 3 sts before
end of instep, ssp, p2, p2tog, p to last 3 sts, ssp, p1. Repeat Rounds 1 and 2 until 28[32, 32] sts remain. 14[16, 16] each on instep and sole. |
![]() |
FINISHING |
![]() |
ABOUT THE DESIGNER |
|
Pattern & images © 2010 Sarah Wilson. Contact Sarah |
![]() |