Go With the Phloem : Knitty.com - Spring + Summer 2019

Go With the Phloem

Go With the Phloem, a free knitting pattern from Knitty.com. Free knitting pattern for a DETAILS HERE.

INTRODUCTION

Go With the Phloem

beauty shot

Tangy

A little known fact about me: Not only did I get a degree in photography, I also acquired one in ecological and evolutionary biology. Nature has always been my primary source of inspiration when it comes to my art and design work, and it's no surprise that it showed up in this pattern. I was inspired by plant biology illustrations of stem cross-sections, with the water transport "holes" (xylem and phloem) visible.

When I started spinning yarn for this project, I decided that I wanted a natural green color with lots of heathering. I compiled some soft white wool, bright green alpaca/silk blend, and some black alpaca and started testing mixtures. I spent time sampling each blend with hand carders and a drop spindle, then when I found the right ratios, I pulled out my drum carder and created some rough mixes. I didn't want my yarn super homogenous, so I purposefully left it variegated. I slightly overspun my singles, so when I plied I would have a high-twist 2-ply yarn ideal for lace.

Though this pi-shawl is relatively straightforward, this pattern does require some focus and attention during the lace rows. The repeat is easy to follow, and creates stunning radial symmetry once the pattern is done.

spacer model: Ariana Krudwig

spacer photos: Benjamin Krudwig

Print Essentials Print Everything

SIZE

One

FINISHED MEASUREMENTS

Diameter: 40 inches/ 102cm

MATERIALS

Fiber:
spacer Hand blended fiber - Wool, alpaca, silk, firestar. Color: heathered green; 6.5 oz

Finished yarn:
spacer Wraps per inch: 22 [Fingering weight]
spacer Ply: 2
spacer Yardage used: ~670 yards
spacer YPP: 1630
spacer Drafting Method: Short forward draw

Commercial yarn alternative:
spacer Jamieson's of Shetland Shetland Spindrift [100% Shetland Wool; 115yds/105m per 25g skein]; color: Turf or Moorgrass

Recommended needle size
[always use a needle size that gives you the gauge listed below - every knitter's gauge is unique]
spacer US #3/3.25mm needles for small circumference in the round
spacer US #3/3.25mm 16-inch/40cm
spacer US #3/3.25mm 24-inch/60cm
spacer US #3/3.25mm 32-inch/80cm
spacer US #3/3.25mm 40-inch/100cm (optional)

Notions
spacer yarn needle
spacer stitch markers – a removable marker is recommended for the first stage of the pattern

GAUGE

28 stitches/32 rows = 4 inches/10cm in stockinette.

PATTERN NOTES

[Knitty's list of standard abbreviations and techniques can be found here.]

With a simple 4-stitch repeat, this pi shawl is a good place to start exploring simple lace techniques. You do need experience working in the round, and the small-circumference start takes a careful hand – although once you're past the first few rounds, it's plain sailing!

Ray Lace:
Rnd 1: *K1, (yo, ssk) 5 times, k1. Repeat from * around.
Rnd 2: Knit
Rnd 3: *K1, (k2tog, yo) 5 times, k1. Repeat from * around.
Rnd 4: Knit

DIRECTIONS

CO 12 sts using needles for small circumference in the round. Distribute sts across needles as you prefer and join for working in the round. Mark start of round – use a removable stitch marker in the fabric.

Note: As the work gets larger, change first to 16-inch/40cm circular needles, placing the start of round marker onto the needle, and then progress to larger needles as required to accommodate the stitches.

Round 1: Knit
Rnd 2: (K1, yo) around. 24 sts.
Rnds 3-9: Knit 7 rnds.
Rnd 10: (K1, yo) around. 48 sts.
Rnd 11-22: Work Ray Lace pattern around. 3 repeats, 12 rounds total.
Rnd 23: (K1, yo) around. 96 sts.
Rnd 24-47: Work Ray Lace pattern around. 6 repeats, 24 rounds total.
Rnd 48: (K1, yo) around. 192 sts.
Rnds 49-96: work Ray Lace pattern around. 12 repeats, 48 rounds total.
Rnd 97: (K1, yo) around. 384 sts.
Rnds 98 - 157: Work Ray Lace pattern around. 15 repeats, 60 rounds total.
Rnd 158: *K1, m1, k3, k2tog, ssk, k3, m1, k1. Repeat from * around
Rnd 159: Knit
Rnd 160-161: Repeat Rnds 158-159.

Bind off as follows: *Bind off 1 st as normal, yo, lift the stitch on right needle over the yo to bind it off; rep from * to end.

FINISHING

Block, using pins or flexible blocking wires to pull out the points of the edging. Weave in ends.

ABOUT THE DESIGNER

designername Benjamin Krudwig is a textile and fashion designer living in Colorado with his wife and two cats. He is drawn to nature, color, and all things fibery. His work can be seen in Spin-Off, Handwoven, Knitty, Uppercase Magazine, and other publications.

Find him online and on Instagram.

Pattern & images © 2019 Benjamin Krudwig.