by Ariel Barton

Cables look wonderful on hats. They look wonderful on socks, or on gloves, or on sweaters. They even look pretty good on pillows and blankets.

But one place they don’t always look so good is the simple rectangular scarf.

Cables tend to have one side that looks intricate and beautiful, and one side that looks much worse. It is easy to arrange a hat, or a sock, or a sweater, or even a blanket, so that only one side is visible. A scarf? It's quite a bit harder.

So I started thinking about reversible cables. I've made a few scarves with reversible cables before, but for this one, I wanted something special. I wanted a relatively large, elaborate pattern running down the middle. I wanted it to look different on both sides, but I still wanted to have it look good on both sides.

This is the result.

SIZE
One

FINISHED MEASUREMENTS
Width: Blue version: 4.75 inches; Cream Version: 5.5 inches
Length: 48 inches; adjustable

MATERIALS
Yarn
Blue Version (shown above):
Dream in Color Jilly [100% merino wool; 440 yd per 100g skein]; color: Tranquil; 2 skeins
Note: a somewhat shorter scarf, about 30--36 inches long, may be made with 1 skein.

Recommended needle size
[always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique]
1 set US #2/2.75mm needles

Cream Version (shown below):
Louet Gems Fine/Sport Weight [100% merino wool; 225 yd per 100g skein]; color: Cream; 2 skeins
Note: A third skein is needed if you wish a longer scarf.

Recommended needle size
[always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique]
1 set US #3/3.25mm

Notions
cable needle
yarn needle

GAUGE

PATTERN NOTES
[Knitty's list of standard abbreviations and techniques can be found here.]

C4L: Slip next 2 sts to cable needle and hold in front, knit 2, knit 2 from cable needle
C4R: Slip next 2 sts to cable needle and hold in back, knit 2, knit 2 from cable needle

T4L: Slip next 2 sts to cable needle and hold in front, purl 2, knit 2 from cable needle
T4R: Slip next 2 sts to cable needle and hold in back, knit 2, purl 2 from cable needle

C4L-Rev: Slip next 2 sts to cable needle and hold in front, purl 2, purl 2 from cable needle
C4R-Rev: Slip next 2 sts to cable needle and hold in back, purl 2, purl 2 from cable needle

Rib-Cable: Slip 4 to cable needle and hold in front, (k1, p1, k1, p1), then (k1, p1, k1, p1) from cable needle.

Cable Pattern
Numbers for Blue version are first; numbers for Cream version in brackets after.

Row 1 [WS]: (K1, p1) 9[8] times, (k2, p4, k2) 3 times, (k1, p1) 9[8] times.

Row 2 [RS]: (K1, p1) 4 times, (p1, k1) 5[4] times, (p2, k4, p2) 3 times, (p1, k1) 5[4] times, (k1, p1) 4 times.

Row 3 [WS]: As Row 1.

Row 4 [RS]: (K1, p1) 4 times; (p1, k1) 5[4] times, p2, (C4R, C4L-Rev) twice, C4R, p2, (p1, k1) 5[4] times, (k1, p1) 4 times.

DIRECTIONS
CO 60(56) sts.

Working from chart or written instructions, work Rows 1-2, then repeat Rows 3-18 until scarf is just about desired length, then work Rows 19-31.

BO in pattern.

FINISHING
Weave in ends. Block by washing gently in warm water with mild detergent, shampoo, Soak or Eucalan. Press between towels and lay flat to dry.

Note: I got better results when I blocked the scarf with the Saxon braid side facing down.

Ariel is a mathematician at the University of Minnesota. In her spare time, she reads, folds origami, and, of course, knits.

You can read about her knitting projects in her journal.