by Mone Dräger

Mitts:



Gloves:

A perfect accessory to wear on a chilly day is fingerless mitts. They do a wonderful job of keeping your wrists and hands comfy and cozy and at the same time your fingers are free for all the tasks that need to be done: texting, typing, knitting, handling money, you get the idea. But not only do they keep your hands warm, they are also fashionable and add a little highlight to your wardrobe.

I designed these as a basic that goes with different outfits and the simple yet elegant design is suitable for women and men alike. The special attribute is the unusual placement of the thumb gusset, which is worked not even near the thumb. The mitts look a bit skew when off the hands, but fit your hands comfortably snug when worn. The mitts are rather long to stay nicely under your coat sleeves to keep out the chill.

There are two versions to choose from: easy-knit Fingerless mitts (shown at left), and a little-more-challenging-but-totally-worth-it fingerless gloves (shown below).

SIZE
Adult Small[Medium, Large]Small, Medium, Large

FINISHED MEASUREMENTS
Hand Circumference: 6.5[7.5, 8.75] inches
Length: 8.5[9.25, 9.75] inches
Note: Choose the size closest to your hand circumference.

Note on sizing: The number of stitches determines not only the width but also the length if the pattern is knit as written. If you wish to make your mitts wider but avoid an increase in length work fewer cuff rounds before beginning the "travelling pattern".

MATERIALS
Yarn
Intrepid Tulips Sock [75% Merino/25% Nylon, 400 yd/366 m per 100g]; 1 skein
Fingerless gloves shown in color: Toronto Teal
Fingerless mitts shown in color: Violet Crush
Note: For either style, the design uses approximately 180[210, 240] yards.

Recommended needle size
[always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique]
US #2/2.75 mm needles for working in the round

Notions
Cable needle
3 stitch markers
Stitch holder or waste yarn
Yarn needle

GAUGE

PATTERN NOTES
[Knitty's list of standard abbreviations and techniques can be found here.]

The mitts and gloves are worked the same way until you hit the upper hand. This design is "un-handed", in that the left and right are the same.

1/1/1 LC: Slip next 2 stitches to cable needle and hold in front of work, k1 tbl, slip last stitch from cable needle to left needle, k1, k1 tbl from cable needle.

RLI (Right Lifted Increase): Insert the right needle into the stitch below the next stitch on the left needle. Pick up this stitch and place it on the left needle, then knit into it. 1 stitch has been increased.

LLI (Left Lifted Increase): Use the left needle to pick up the stitch 2 rows below the last stitch on the right needle. Knit into this stitch. 1 stitch has been increased.

Twisted Rib Pattern (over an even number of stitches, worked in the round):
Round 1: [K1 tbl, p1] to end.
Note that as you work the "travelling pattern", some rounds will have the rib start with a purl stitch, some with k1 tbl. Always work the stitches as they lie.

DIRECTIONS

Work 20[15, 10] rounds in Rib Pattern.

Round 1: 1/1/1 LC, place marker after the first stitch of the cable for start of round. Work in Rib Pattern as set to end of round.

Round 2: K1, work in Rib pattern as set to end of round.

Round 3: K1, LLI, pm, work in Rib pattern to end of round, pm, RLI. 52[60, 70] stitches

Round 4: K2, work in Rib pattern to last stitch, k1.

Round 5: K to marker, LLI, slip marker, ssk, work in Rib pattern to two stitches before next marker, k2tog, slip marker, RLI, k to end of round.

Round 6: K to marker, work in Rib pattern to next marker, k to end.

Repeat Rounds 5 & 6 4[6, 8] more times.

Round 7: K to marker, LLI, slip marker, ssk, work in Rib pattern to two stitches before next marker, k2tog, slip marker, RLI, k to end of round.

Round 8: K to marker, work in Rib pattern to next marker, k to end.

Round 9: K to marker, LLI, slip marker, work in Rib pattern to next marker, slip marker, RLI, k to end of round. 2 sts increased.

Round 10: K to marker, work in Rib pattern to next marker, k to end.

Repeat Rounds 7 to 10 6[7, 8] more times. 66[76, 88] stitches

Next round, divide for thumb: K to marker, LLI, slip marker, ssk, work 2[2, 3] sts in Rib pattern, place next 17[19, 21] stitches on waste yarn or stitch holder, cast on 3 stitches using backward loop method, work in Rib pattern to next marker, k2tog, slip marker, slip marker, k2tog, RLI, k to end of round. 52[60, 70] stitches total, 9[9, 11] stitches between markers.

Next round: K to marker and remove, sl1, k2tog, psso, remove marker, k to end of round. 50[58, 68] stitches.

Work even in stockinette until the mitt reaches the base of your pinky, approximately 6 rounds.

Mittens Only
Top edge round: Work Rib pattern around.
Work 6 rounds of Rib pattern as set, or to desired length.
Bind off loosely in pattern.

Proceed to Thumb.

Hand
Return held sts to needles. Rejoin yarn next to base of pinky.

K38[44, 52], pick up and knit 3 sts from the base of the pinky. 41[47, 55] stitches.

Distribute sts across needles as you prefer and join for working in the round.

Knit 2[3, 4] rounds.

Ring finger
K6[7, 8], put next 27[31, 36] stitches on hold, CO 4[4, 3] using backwards loop, k the last 8[9, 11] sts. 18[20, 22] stitches.

Knit 6[7, 8] rounds or to desired length.

Bind off loosely.

Middle finger
Return held sts to needles and rejoin yarn at the start.

K5[6, 8], put next 16[18, 20] stitches on hold, CO 3 using backwards loop, k the last 6[7, 8] sts and pick up and knit 4[4, 3] sts from base of ring finger. 18[20, 22] sts.

Knit 7[8, 9] rounds or to desired length. Bind off loosely.

Index Finger
Return held sts to needles and rejoin yarn at the start.
Knit 16[18, 20] and pick up and knit 3 stitches from base of middle finger. 19[21, 23] sts.
Knit 6[7, 8] rounds or to desired length.
Bind off loosely.

Thumb - Both Styles:
Return 17[19, 21] thumb stitches from holder on needle. Distribute sts across needles as you prefer, and with RS facing, rejoin yarn.
Round 1: Work 17[19, 21] sts in Rib pattern and pick up and knit 3 stitches from CO sts of the hand. 20[22, 24] stitches.
Join for working in the round.
Work 10[11, 12] rounds in Rib pattern or to desired length. Bind off loosely in pattern.

FINISHING
Block and weave in all ends. The ends can be used to close up any holes that may have formed between fingers, and where you picked up the additional stitches for the thumb.

Mone lives in a small village in Northern Germany and loves to craft and be creative. You often find her sewing, taking pictures or gardening and most often knitting and working on new pattern ideas. She has a special fancy for accessories and loves to give basic patterns a new twist with a different construction.

Find her on Ravelry.