Editor's note: This pattern was the winning entry in our Knittyspin/Spunky Eclectic/Spin Control contest! Congratulations, Kristy!

The Spunky Eclectic booth was my favorite at the Maine Fiber Frolic.  I fell in love with the Burning Embers colorway, especially when I opened up the braid and saw the large patches of color and the way it was brighter at one end and darker at the other.

I decided to split it once lengthwise and begin spinning at the same end on each bobbin to preserve the long color changes. The result was a soft, lovely two ply yarn with colors that blended gently without being too stripey.

I wanted to knit a cowl, but I knew it would have to be different from the other patterns I’ve seen.

SIZE
One

FINISHED MEASUREMENTS
Neck circumference: 14 inches
Lower edge circumference: 36 inches
Length: 8.5 inches

	Spinning Tool: Majacraft Pioneer; scotch tension, 10:1 ratio

Finished Yarn:
Wraps per inch: 12
Yield: 248 yards
Yardage used: approx. 150 yards

Drafting Method:
Short forward draw

Commercial Yarn Alternative
Use a wool yarn with a recommended gauge of approx. 18 sts = 4 inches. A yarn with long color changes would be most like the sample piece, such as Noro Kureyon.
Noro Kureyon [100% wool; 110yd/101m per 50g skein]; 2 skeins

Recommended needle size
[always use a needle size that gives you the gauge listed below -- every knitter's gauge is unique]
1 24- or 32-inch US #7/4.5mm circular needle
1 additional US #7/4.5mm circular needle or set  of double-point needles
Note: Sample was knit using the Magic Loop technique once circumference of piece became too small for circular needle. Double-point needles or two circular needles could be used instead, if preferred.

Tools
Yarn needle

GAUGE
18 sts/28 rows = 4" in stockinette st

PATTERN NOTES
[Knitty's list of standard abbreviations and techniques can be found here.]

Annie Modesitt’s Slip Stitch Edge
Note: When working this edging, sts are slipped with yarn held to front of work.
RS Rows: K1, sl 1, k1; work in pattern to last 3 sts, k1, sl 1, k1.
WS Rows: Sl 1, k1, sl 1, work in pattern to last 3 stitches, sl 1, k1, sl 1.

This project may be worked using 2 circular needles. If you are unfamiliar with this technique, instructions may be found here.

A tutorial for the Magic Loop technique may be found here.

DIRECTIONS
Using circular needle, CO 161 sts. Place marker and join to begin working in the round, being careful not to twist.

Work Rounds 1-21 of Chart A. Chart pattern will be worked 7 times in each round. When all rounds have been completed, 112 sts remain.

Work in stockinette st until piece measures 4 inches. Measure length at points between scallops, where work is the shortest.

Decrease for Neck:
From this point, piece will be worked back and forth in rows. Work Annie Modesitt’s Slip Stitch Edge over first and last 3 sts.

Row 1 [RS]: Work edging, k4, k2tog, [k7, k2tog] 11 times, k1, work edging. 100 sts.

Rows 2 & 4 [WS]: Work edging, p to last 3 sts, work edging.

Row 3 [RS]: Work edging, k3, k2tog, [k6, k2tog] 11 times, k1, work edging. 88 sts.

Row 5 [RS]: Work edging, k2, k2tog, [k5, k2tog] 11 times, k1, work edging. 76 sts.

Row 6 [WS]: Work edging, p2tog, p to last 3 sts, work edging. 75 sts.

Work Rows 1-12 of Chart B, maintaining edging over first and last 3 sts as set. Chart pattern will be worked 3 times in each row.
BO all sts loosely.

FINISHING
Weave in ends and block lightly. Sew buttons along one edge as shown. To button cowl, use yarnovers from lace pattern as buttonholes.

Kristy knits, reads, and spins (not necessarily in that order) in northern Maine. She can be found on Ravelry as kristyh.